Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 39
Page 7
THEORETICAL ANALYSIS : MEASUREMENT AND PREDICTION OF WELDING RESIDUAL STRESSES USING FEM Yukio Ueda and Keiji Nakacho ... Materials Engineering ASME - 1991 ABSTRACT as a For prediction of welding residual stress , the authors have ...
THEORETICAL ANALYSIS : MEASUREMENT AND PREDICTION OF WELDING RESIDUAL STRESSES USING FEM Yukio Ueda and Keiji Nakacho ... Materials Engineering ASME - 1991 ABSTRACT as a For prediction of welding residual stress , the authors have ...
Page 14
Then , residual stress in butt - welded plate can be estimated as follows . As a standard inherent strain ... Residual stresses in different butt - welded plates estimated by this method are represented in Fig.16 using several marks .
Then , residual stress in butt - welded plate can be estimated as follows . As a standard inherent strain ... Residual stresses in different butt - welded plates estimated by this method are represented in Fig.16 using several marks .
Page 272
Residual stress distributions in the coatings of both A - type and B - type specimens were of tension and the residual stress levels was less than about 100MPa . On the other hand , those of C - type specimens were lower because of ...
Residual stress distributions in the coatings of both A - type and B - type specimens were of tension and the residual stress levels was less than about 100MPa . On the other hand , those of C - type specimens were lower because of ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
WELD METAL AND HAZ PROPERTIES | 37 |
The Effect of Intercritical Thermal Cycles on HAZ Microstructure and Toughness in CMnAlNb | 49 |
Copyright | |
13 other sections not shown
Other editions - View all
Common terms and phrases
alloys analysis application austenite axial base bead behaviour boundary calculated carbon CGHAZ changes chemical compared composition considered cooling crack crack tip critical CTOD curves cycle deformation developed direction distribution effect element energy Engineering evaluation experimental fatigue ferrite field Figure fracture toughness fusion gauges geometry Grade grain grain boundary groove hardness heat heat input higher increase initiation load lower material measured mechanical method microstructure narrow notched observed obtained offshore operation panel parameters pass performed pipe plate position possible prediction present pressure procedure produced properties range reduced regions requirements residual stress resistance samples shown shows simulation specimen steel strain strength structure surface Table temperature tempered tensile thermal thickness titanium values volume weld metal welded joint width yield zone
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1991 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791807193, 9780791807194 |
| Export Citation | BiBTeX EndNote RefMan |