Solid State Behavior of Linear Polyesters and Polyamides |
From inside the book
Results 1-3 of 65
Page 141
... determined from wide - angle symmetrical transmission X - ray diffractomer patterns [ 13 ] . Crystallinity was measured using the Roldan , Rahl , and Patterson method [ 14 ] , which was developed for the analysis of nylon 6 ...
... determined from wide - angle symmetrical transmission X - ray diffractomer patterns [ 13 ] . Crystallinity was measured using the Roldan , Rahl , and Patterson method [ 14 ] , which was developed for the analysis of nylon 6 ...
Page 152
... determined solely by the modulus of the microfibril , which in turn is determined by the combination of the moduli of the alternating amorphous and crystalline regions when they are loaded under conditions of equal stress ( i.e. ...
... determined solely by the modulus of the microfibril , which in turn is determined by the combination of the moduli of the alternating amorphous and crystalline regions when they are loaded under conditions of equal stress ( i.e. ...
Page 191
... determined by comparing the diameter of the fiber at any point in the drawing process with the undrawn fiber ; the final draw ratio is determined by comparing the fiber diameter of the final drawn fiber with the undrawn fiber . ) In all ...
... determined by comparing the diameter of the fiber at any point in the drawing process with the undrawn fiber ; the final draw ratio is determined by comparing the fiber diameter of the final drawn fiber with the undrawn fiber . ) In all ...
Contents
SOLID STATE REACTIONS IN LINEAR | 1 |
CHEMICAL HEALING | 43 |
PRACTICAL ASPECTS OF ADDITIONAL SOLID STATE | 59 |
Copyright | |
19 other sections not shown
Other editions - View all
Common terms and phrases
acid additional solid amorphous annealing Appl aspect ratio behavior birefringence block temperature chain Chem composites copolyester copolymer courtesy crystallinity crystallization curves decreases deformation degree of crystallinity density diameter diffusion domains Dröscher effect Equation exchange reactions extrusion temperature Fakirov fiber axis fibers drawn filament fracture mechanics fracture toughness function heat of fusion heated element higher increasing initial kg/cm² kinetics linear polycondensates load macromolecules Makromol material matrix maximum measurements mechanical melting point microfibrils microstructure mm/min modulus molded molecules morphology nominal draw ratio noncrystalline nylon 6 fibers nylon 66 orientation parameters peak PET fibers phase Phys polyamides polyesters Polymer Sci polymerization properties Reprinted from Ref samples SAXS Schultz semicrystalline shown in Figure solid state polycondensation solid state post-polycondensation solid state reactions Solid-state extrusion specimen spherulite strength stress structure Table tensile terephthalate thermoplastics toughened transesterification transreactions values x-ray yield Zachmann