Solid State Behavior of Linear Polyesters and Polyamides |
From inside the book
Results 1-3 of 5
Page 24
... increases at a given terephthalate content [ 61 ] ; ( 3 ) Theil Q factor , which is a measure of ... rise in the melting point and a 64 % increase in crystallinity , most of ... temperature of solid state polycondensation . Conse- quently ...
... increases at a given terephthalate content [ 61 ] ; ( 3 ) Theil Q factor , which is a measure of ... rise in the melting point and a 64 % increase in crystallinity , most of ... temperature of solid state polycondensation . Conse- quently ...
Page 115
... temperature of the mesophase is higher than that of the isotropic component ... rise to the SAXS pattern , simulated scattering from model structures can ... temperature on the intensity of the small - angle Bragg maxima has also proven ...
... temperature of the mesophase is higher than that of the isotropic component ... rise to the SAXS pattern , simulated scattering from model structures can ... temperature on the intensity of the small - angle Bragg maxima has also proven ...
Page 220
... increase of the melting temperature with pressure as large as 160 K GPa ̄1 . Newman et al . found that the a → y transition occurs under atmospheric pressure at 95 ° C . The transition temperature increased with pressure at a rate of ...
... increase of the melting temperature with pressure as large as 160 K GPa ̄1 . Newman et al . found that the a → y transition occurs under atmospheric pressure at 95 ° C . The transition temperature increased with pressure at a rate of ...
Contents
SOLID STATE REACTIONS IN LINEAR | 1 |
TRANSREACTIONS AND POSTADDITIONAL | 19 |
CHEMICAL HEALING | 43 |
Copyright | |
21 other sections not shown
Other editions - View all
Common terms and phrases
acid additional solid amorphous annealing Appl aspect ratio behavior birefringence block temperature chain Chem chemical healing composites copolyester copolymer courtesy crystallinity crystallization curves decreases deformation degree of crystallinity density diameter diffusion domains effect Equation exchange reactions extrusion temperature Fakirov fiber axis fibers drawn filament fracture mechanics fracture toughness function heat of fusion heated element higher increasing initial kg/cm² kinetics linear polycondensates macromolecules Makromol material matrix maximum measurements mechanical melting point microfibrils microstructure mm/min modulus molding molecules morphology nominal draw ratio noncrystalline nylon 6 fibers nylon 66 orientation parameters peak PET fibers phase Phys polyamides polyesters Polymer Sci polymerization properties Reprinted from Ref samples SAXS Schultz semicrystalline shown in Figure solid state polycondensation solid state post-polycondensation solid state reactions Solid-state extrusion specimen spherulite strength stress structure Table tensile terephthalate thermoplastics toughened transesterification transreactions values x-ray yield Zachmann