Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 7, Parts 4-6American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 84
Page 14
... strain rate ( 10-3s - 1 ) tension test . The specimen is necked so that stresses over 1 MPa are obtainable without end - cap failures . The extensometers are attached by rubber bands and seat on felt pads frozen to the sample . Specimen ...
... strain rate ( 10-3s - 1 ) tension test . The specimen is necked so that stresses over 1 MPa are obtainable without end - cap failures . The extensometers are attached by rubber bands and seat on felt pads frozen to the sample . Specimen ...
Page 22
... Strain ( 10-4 Fig . 8 The stress - strain curves of ice at different temperatures and at the strain rate of 5x10-13-1 Fig.5 The stress - strain curves of ice at five different strain rates and at the temperature of 253K . S . 10 ...
... Strain ( 10-4 Fig . 8 The stress - strain curves of ice at different temperatures and at the strain rate of 5x10-13-1 Fig.5 The stress - strain curves of ice at five different strain rates and at the temperature of 253K . S . 10 ...
Page 120
... Strain rate usually was set to three nominal strain rates ( 10-5 , 10-4 and 10-3 s1 ) . Some tests were performed down to 3x10-6 or up to 10-2 s1 . - Temperature was usually kept at -2 ° C but two series of tests were performed at -10 ...
... Strain rate usually was set to three nominal strain rates ( 10-5 , 10-4 and 10-3 s1 ) . Some tests were performed down to 3x10-6 or up to 10-2 s1 . - Temperature was usually kept at -2 ° C but two series of tests were performed at -10 ...
Contents
ICE PROPERTIESII | 31 |
The Growth of EGADS Model Ice in a Small Tank | 47 |
ICE DRIFT AND DYNAMICS | 69 |
Copyright | |
36 other sections not shown
Other editions - View all
Common terms and phrases
analysis angle Arctic Arctic Engineering average axial beam Beaufort Sea bending Bering Sea buckling calculated compressive Conference on Offshore corrosion crack creep curve cylinder deflection deformation density depth developed dew point diameter displacement dynamic effect elastic equation experimental failure finite element flow fracture fracture toughness free span function horizontal ice force ice loads ice sheet ice velocity icebreaking impact increase layer length lift force linear material maximum measured Mechanics and Arctic method nodal analysis normal force Offshore Mechanics operating parameters pipe pipeline plastic predicted presented pressure PVDF ratio ray tracing regular waves riser samples SCADA scour sea ice seabed Seventh International Conference shear ship shown in Figure simulation soil specimen spray ice steel strain gauges strain rate stress structure surface temperature tensile thermosyphon thickness tion values vertical welding zone