Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 7, Parts 4-6American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 84
Page 14
... strain rate ( 10-3s - 1 ) tension test . The specimen is necked so that stresses over 1 MPa are obtainable without end - cap failures . The extensometers are attached by rubber bands and seat on felt pads frozen to the sample . Specimen ...
... strain rate ( 10-3s - 1 ) tension test . The specimen is necked so that stresses over 1 MPa are obtainable without end - cap failures . The extensometers are attached by rubber bands and seat on felt pads frozen to the sample . Specimen ...
Page 22
... Strain ( 10-4 Fig . 8 The stress - strain curves of ice at different temperatures and at the strain rate of 5x10-13-1 Fig.5 The stress - strain curves of ice at five different strain rates and at the temperature of 253K . S . 10 ...
... Strain ( 10-4 Fig . 8 The stress - strain curves of ice at different temperatures and at the strain rate of 5x10-13-1 Fig.5 The stress - strain curves of ice at five different strain rates and at the temperature of 253K . S . 10 ...
Page 120
... Strain rate usually was to three nominal strain rates ( 10-5 , 104 and 10-3 s ̄1 ) . Some tests were performed down to 3x10-6 or up to 10-2 s1 . Temperature was usually kept at -2 ° C but two series of tests were performed at -10 ° C ...
... Strain rate usually was to three nominal strain rates ( 10-5 , 104 and 10-3 s ̄1 ) . Some tests were performed down to 3x10-6 or up to 10-2 s1 . Temperature was usually kept at -2 ° C but two series of tests were performed at -10 ° C ...
Contents
ICE PROPERTIESII | 31 |
Simple Beam Tests on Type S3 Sea | 63 |
ICE DRIFT AND DYNAMICS | 69 |
Copyright | |
32 other sections not shown
Other editions - View all
Common terms and phrases
analysis angle approximately Arctic assumed average beam calculated coefficient Cold conducted Conference constant crack creep crushing curves deflection deformation dependence determined developed drift dynamic effect elastic energy Engineering equation estimated experimental experiments factor failure field Figure flexural flow force fracture friction function given grain heat horizontal ice force ice loads ice sheet iceberg impact increase indicates International island layer length limit linear material mean measured Mechanics method motion normal Norton Sound observed obtained Ocean Offshore operating oriented panel parameters plate POSITION presented pressure properties range ratio reference region reinforced relative Report Research response saline samples scale sea ice shape ship shown shows specimen speed spray strain rate strength stress structure surface Table temperature tests thermosyphon thickness tion transfer values vertical wind