## Microstructure of Cement-Based Systems: Volume 370: Bonding and Interfaces in Cementitious MaterialsS. Diamond, F. P. Glasser, S. Mindess, L. R. Roberts, J. P. Skalny, L. D. Wakeley This book continues the MRS series on characteristics and properties of cementitious materials. In Part I, recent advances in microstructure and related characterization of cementitious systems are the focus. Topics include: microstructures of "normal" cement systems; microstructure of 'unusual' cement systems; image analysis, modelling and fractal analysis applications; and assessment of pore structures. Part II features presentations on interfacial microstructures, as well as information on elastic and fracture properties, transport properties, and the effects of interfaces on fiber-reinforced systems. |

### From inside the book

Results 1-3 of 45

Page 409

Based on the above values , the calculation of the average dynamic

pasteaggregate interfaces will consider values of 10 , 30 , or 50 um as ... So , the

second step is to expand the LMR for

Based on the above values , the calculation of the average dynamic

**moduli**ofpasteaggregate interfaces will consider values of 10 , 30 , or 50 um as ... So , the

second step is to expand the LMR for

**modulus**of elasticity to three phases .Page 411

0 SF Mortar SF Mortar PC Mortar PC Mortar PC Paste PC Paste SF Paste SF

Paste Dynamic Shear

psi ) versus age ( days ) for mortar , paste , and interfacial zones with assumed ...

0 SF Mortar SF Mortar PC Mortar PC Mortar PC Paste PC Paste SF Paste SF

Paste Dynamic Shear

**Modulus**( x100 psi ) ... Dynamic**moduli**of elasticity ( * 10°psi ) versus age ( days ) for mortar , paste , and interfacial zones with assumed ...

Page 416

If the matrix of each specimen was homogeneous , the effective bulk

the mortar would be expected to lie near ... This is because the effective

of a composite is mainly controlled by the matrix phase , not the inclusions , and

in ...

If the matrix of each specimen was homogeneous , the effective bulk

**moduli**ofthe mortar would be expected to lie near ... This is because the effective

**modulus**of a composite is mainly controlled by the matrix phase , not the inclusions , and

in ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Common terms and phrases

addition aggregate amount analysis applied average bending bond bulk calcium calculated carbonate cement paste cementitious changes chemical clinker compared composite compressive concentration concrete containing crack crystals cured curve decrease density determined developed diameter diffusion distribution effect elastic electron energy experimental fiber Figure formation fracture surface given grains hardened higher hydration increase indicate influence interfacial zone length load lower materials matrix measured mechanical method microstructure mixes modulus mortar observed obtained occurs parameters particles performance phase pore porosity portland cement prepared present Proc properties pullout range ratio reinforced relative Research respectively rock samples sand shown shows silica fume similar solution specimens steel strength stress structure surface Table technique thickness transition zone values voids volume volume fraction