## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 75

Page 37

11 by the steep line to the left of the stress axis on the stress vs time plot for both

the Kelvin and the

in the Kelvin model the initial strain is zero , whereas in the

11 by the steep line to the left of the stress axis on the stress vs time plot for both

the Kelvin and the

**Maxwell**models . The initial rigidity of the dashpot means thatin the Kelvin model the initial strain is zero , whereas in the

**Maxwell**model the ...Page 42

strain is the sum of the strain of the

Kelvin , E = em + EK while the stress imposed upon each is the applied stress o =

om = OK These same conditions on strain and on stress apply at all times and for

...

strain is the sum of the strain of the

**Maxwell**component plus the strain of theKelvin , E = em + EK while the stress imposed upon each is the applied stress o =

om = OK These same conditions on strain and on stress apply at all times and for

...

Page 119

9 Relaxation of linear

linearly with time from its elastic value de = ML / EMI . This rotational creep for a

beamlike assemblage is the analog of the axial creep in a

tension ...

9 Relaxation of linear

**Maxwell**assemblage . O const M = Moe - ( EM / CM )linearly with time from its elastic value de = ML / EMI . This rotational creep for a

beamlike assemblage is the analog of the axial creep in a

**Maxwell**bar undertension ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

acts actual addition angle answer applied assemblage axial axis beam behavior bending carry circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve deflection deformation determined diameter dimensions direction displacement effect elastic equal equation example Figure Find force given gives homogeneous idealization increase independent initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires response result rotation shear stress shell shown shows simple sketch solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled tube twisting uniform unloading versus viscous yield zero