## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 89

Page 194

3 : 17 ) T a3 + b3 Pa 2v Therefore a compressive

required to prevent relative

constraint w = 0 is dropped and an additional external

the ...

3 : 17 ) T a3 + b3 Pa 2v Therefore a compressive

**axial**force of F – ( Pi + P2 ) isrequired to prevent relative

**axial**motion w of the end plates of Fig . 9 . 11 . If theconstraint w = 0 is dropped and an additional external

**axial**force R is applied tothe ...

Page 208

The total stress is always just the sum of the stresses which would be caused by

each load acting alone and so is determined by the loads without reference to the

properties of the material other than the homogeneity associated with

The total stress is always just the sum of the stresses which would be caused by

each load acting alone and so is determined by the loads without reference to the

properties of the material other than the homogeneity associated with

**axial**...Page 210

4 / YIELD CURVES AND SURFACES ( IN STRESS SPACE ) Suppose now that a

number of closed - end thin - walled circular tubes of a particular structural metal

are tested under various combinations of

4 / YIELD CURVES AND SURFACES ( IN STRESS SPACE ) Suppose now that a

number of closed - end thin - walled circular tubes of a particular structural metal

are tested under various combinations of

**axial**force R , interior pressure p , and ...### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

acts actual addition angle answer applied assemblage axial axis beam behavior bending carry circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve deflection deformation determined diameter dimensions direction displacement effect elastic equal equation example Figure Find force given gives homogeneous idealization increase initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires response result rotation shear stress shell shown shows simple sketch solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled tube twisting uniform viscous yield zero