## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 63

Page 199

chapter 10

SOLUTIONS You now are able to solve many problems of reasonable complexity

and importance involving inhomogeneous states of stress and a variety of time ...

chapter 10

**Combined**loading . superposition 10 . 1 / SUPERPOSITION OFSOLUTIONS You now are able to solve many problems of reasonable complexity

and importance involving inhomogeneous states of stress and a variety of time ...

Page 205

hand , when two deformations or strains are imposed on any system , it is the

separate stresses for each which will not add together to give the answer for the

hand , when two deformations or strains are imposed on any system , it is the

separate stresses for each which will not add together to give the answer for the

**combined**deformation . The solution to other than fully linear problems of**combined**...Page 374

11 / PROBLEMS OF

of materials approach of this chapter and the discussion of principal stresses and

strains in Chap . 11 permit us to reconsider the bar problems of Chap . 1 and to ...

11 / PROBLEMS OF

**COMBINED**STRESS ,**COMBINED**LOADING The strengthof materials approach of this chapter and the discussion of principal stresses and

strains in Chap . 11 permit us to reconsider the bar problems of Chap . 1 and to ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

acts actual addition angle answer applied assemblage axial axis beam behavior bending carry circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve deflection deformation determined diameter dimensions direction displacement effect elastic equal equation example Figure Find force given gives homogeneous idealization increase independent initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires response result rotation shear stress shell shown shows simple sketch solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled tube twisting uniform unloading versus viscous yield zero