## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 53

Page 247

23

respectively . Point A , originally on the x axis a distance Ax from 0 , goes to A ' .

23

**Displacement**, deformation , and distortion . torted in general . The**displacement**components of O are labeled u , v , w in the x , y , z directions ,respectively . Point A , originally on the x axis a distance Ax from 0 , goes to A ' .

Page 378

This trivial illustration does bring out three important features . The first is that the

type and magnitude of the

virtual work need bear no relation to the character of the actual

...

This trivial illustration does bring out three important features . The first is that the

type and magnitude of the

**displacements**u * chosen for the computation of thevirtual work need bear no relation to the character of the actual

**displacement**u of...

Page 390

Which layout is better ? Why ? What modification would you employ if the total

balance weight is restricted to 10 lb ? 15 . 2 Find vc , the downward vertical

component of

work . 15 .

Which layout is better ? Why ? What modification would you employ if the total

balance weight is restricted to 10 lb ? 15 . 2 Find vc , the downward vertical

component of

**displacement**of pin C ( Fig . 15 . 5 ) . Use the equation of virtualwork . 15 .

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

acts actual addition angle answer applied assemblage axial axis beam behavior bending carry circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve deflection deformation determined diameter dimensions direction displacement effect elastic equal equation example Figure Find force given gives homogeneous idealization increase independent initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires response result rotation shear stress shell shown shows simple sketch solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled tube twisting uniform unloading versus viscous yield zero