## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 81

Page 97

In each of the

equation than there are unknown forces . One more relation is needed to solve

the problem . The additional equation is given by the geometry of the deformation

and ...

In each of the

**examples**, the full use of statics leads to one less independentequation than there are unknown forces . One more relation is needed to solve

the problem . The additional equation is given by the geometry of the deformation

and ...

Page 99

5 / ILLUSTRATIVE

Two long , thin - walled concentric tubes fastened between rigid end plates which

are pulled apart with a force R ( Fig . 6 . 4 ) provide an interesting

5 / ILLUSTRATIVE

**EXAMPLE**OF A STATICALLY INDETERMINATE SYSTEMTwo long , thin - walled concentric tubes fastened between rigid end plates which

are pulled apart with a force R ( Fig . 6 . 4 ) provide an interesting

**example**of a ...Page 322

16 are but a few

bending under transverse force . All are

discontinuous variations in force ( moment ) or cross section along their length .

Almost all ...

16 are but a few

**examples**of that most important class of bodies , beams inbending under transverse force . All are

**examples**of bars with continuous ordiscontinuous variations in force ( moment ) or cross section along their length .

Almost all ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

acts actual addition angle answer applied assemblage axial axis beam behavior bending carry circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve deflection deformation determined diameter dimensions direction displacement effect elastic equal equation example Figure Find force given gives homogeneous idealization increase independent initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires response result rotation shear stress shell shown shows simple sketch solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled tube twisting uniform unloading versus viscous yield zero