## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 82

Page 38

An obvious particular

Upon putting the differential equation in standard form , de + Eke the

the homogeneous equation ( right - hand side set equal to zero ) is e = Be - ( Ex ...

An obvious particular

**solution**is e = 01 / EK , which is the asymptotic value of e .Upon putting the differential equation in standard form , de + Eke the

**solution**tothe homogeneous equation ( right - hand side set equal to zero ) is e = Be - ( Ex ...

Page 169

The answer found is correct , but remember that in general a

the

, for fully stable materials and bodies , the history of the applied loading ...

The answer found is correct , but remember that in general a

**solution**may not bethe

**solution**. Uniqueness must be studied or at least stated . The statement is that, for fully stable materials and bodies , the history of the applied loading ...

Page 329

Analytic

the moment - curvature or torque - twist curve by linear - elastic response clear up

to a plastic - limit moment M , or To , at which point the deformation is unlimited ...

Analytic

**solution**is possible when the further approximation is made of replacingthe moment - curvature or torque - twist curve by linear - elastic response clear up

to a plastic - limit moment M , or To , at which point the deformation is unlimited ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

acts actual addition angle answer applied assemblage axial axis beam behavior bending carry circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve deflection deformation determined diameter dimensions direction displacement effect elastic equal equation example Figure Find force given gives homogeneous idealization increase independent initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires response result rotation shear stress shell shown shows simple sketch solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled tube twisting uniform unloading versus viscous yield zero