## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 4American Society of Mechanical Engineers, 2001 - Arctic regions |

### From inside the book

Results 1-3 of 45

Page 266

The net uplift force depends on the resistance of the

changes with different

net uplift force , J is the effective unit weight of the

The net uplift force depends on the resistance of the

**soil**above and thereforechanges with different

**soils**and**soil**states . ... Line of symmetry where W , is thenet uplift force , J is the effective unit weight of the

**soil**and L is the pipe length .Page 267

There is a line of symmetry in the centre of the pipe , so only half of the pipe -

system needed to be modelled and the line of symmetry was replaced by a

rolling , rigid boundary . The

There is a line of symmetry in the centre of the pipe , so only half of the pipe -

**soil**system needed to be modelled and the line of symmetry was replaced by a

rolling , rigid boundary . The

**soil**was modelled using 525 linear strain triangles .Page 271

3 Observed

shows a digital photograph of the

1 . 3 through loose sand in the laboratory ( test 1 ) . The initial embedment ratio ,

H / D ...

3 Observed

**soil**displacement mechanisms 5 . 3 . 1 Loose sand Figure 10ashows a digital photograph of the

**soil**model after a pipe displacement of S / D =1 . 3 through loose sand in the laboratory ( test 1 ) . The initial embedment ratio ,

H / D ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

analysis applied approach Arctic assessment axial bending buckle cable calculated carrier cause coefficient collapse combination compared Conference considered corrosion cost crack damage defect depth detailed determined developed diameter displacement distribution dynamic effect element Engineering equation experimental factor failure field Figure flexible flow flowline fluid force foundation fracture function geometry given grooves heat increase initial inspection installation internal lateral layer length limit liner load material maximum measured Mechanics method observed obtained occur Offshore operation parameters performed phase pipe pipeline position predicted presented pressure production range ratio reduced relation resistance respectively response riser risk sand seabed shown shows simulation soil solution specimens steel stiffness strain strength stress structure surface Table temperature tests thermal thickness values wave wrinkle