## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 4American Society of Mechanical Engineers, 2001 - Arctic regions |

### From inside the book

Results 1-3 of 85

Page 12

Characteristic

N ) The same process of ice force can be expressed in two different ways , one is

frequency spectrum and the other is characteristic ice force

...

Characteristic

**values**of ice forces and zero order moments of spectra Fh , 1 / 3 (N ) The same process of ice force can be expressed in two different ways , one is

frequency spectrum and the other is characteristic ice force

**values**. A correlation...

Page 84

The relative differences of the U

correlation coefficient r , and the standard error S of two models are listed in

Table 2 . For the three flowline heated cases , the inner area used is the total

area of ...

The relative differences of the U

**values**are also listed in the table . The factor d ,correlation coefficient r , and the standard error S of two models are listed in

Table 2 . For the three flowline heated cases , the inner area used is the total

area of ...

Page 199

For typical

been assumed . Therefore the limit ... Field measurements of pipeline forces (

Wilkinson and Palmer , 1988 ) showed that for

of ...

For typical

**values**of s = 2 . 65 and sp = 1 . ... A typical**value**of D / d = 3000 hasbeen assumed . Therefore the limit ... Field measurements of pipeline forces (

Wilkinson and Palmer , 1988 ) showed that for

**values**of A / D up to 1 . 5 the**value**of ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

analysis applied approach Arctic assessment axial bending buckle cable calculated carrier cause coefficient collapse combination compared Conference considered corrosion cost crack damage defect depth detailed determined developed diameter displacement distribution dynamic effect element Engineering equation experimental factor failure field Figure flexible flow flowline fluid force foundation fracture function geometry given grooves heat increase initial inspection installation internal lateral layer length limit liner load material maximum measured Mechanics method observed obtained occur Offshore operation parameters performed phase pipe pipeline position predicted presented pressure production range ratio reduced relation resistance respectively response riser risk sand seabed shown shows simulation soil solution specimens steel stiffness strain strength stress structure surface Table temperature tests thermal thickness values wave wrinkle