International Residential Code for One- and Two-family DwellingsThe 2000 International Residential Code brings uniformity to the construction of one- and two-family dwellings and townhouses. A comprehensive code for building design, this book brings together all building, plumbing, mechanical, and fuel gas provisions. It establishes minimum regulations using prescriptive provisions, and is founded on broad-based principles that make possible the use of materials and building designs. |
From inside the book
Results 1-3 of 93
Page 166
... exceed three times their thickness . Ma- sonry parapet walls in areas subject to wind loads of 30 pounds per square foot ( 1.44 kN / m2 ) or located in Seismic Design Category D1 or D2 shall be reinforced in accordance with Section R606 ...
... exceed three times their thickness . Ma- sonry parapet walls in areas subject to wind loads of 30 pounds per square foot ( 1.44 kN / m2 ) or located in Seismic Design Category D1 or D2 shall be reinforced in accordance with Section R606 ...
Page 175
... exceed the 4 - inch ( 102 mm ) nominal dimension provided tie size and tie spac- ing have been established by calculation . R608.1.1 Bonding with masonry headers . Bonding with solid or hollow masonry headers shall comply with Sections ...
... exceed the 4 - inch ( 102 mm ) nominal dimension provided tie size and tie spac- ing have been established by calculation . R608.1.1 Bonding with masonry headers . Bonding with solid or hollow masonry headers shall comply with Sections ...
Page 483
... exceed that marked on the appliance . Where the overcurrent protection rating is not marked and the appliance is rated at over 13.3 amperes , the overcurrent protection shall not exceed 150 percent of the appliance rated current . Where ...
... exceed that marked on the appliance . Where the overcurrent protection rating is not marked and the appliance is rated at over 13.3 amperes , the overcurrent protection shall not exceed 150 percent of the appliance rated current . Where ...
Contents
AE302 Application for Permit | 3 |
E3509 Bonding | 20 |
P2605 Support | 384 |
Copyright | |
10 other sections not shown
Other editions - View all
Common terms and phrases
12 inches accor accordance with Section accordance with Table air admittance valve appliance applied approved ASTM braced wall line braced wall panels ceiling joists clearance cold-formed steel comply concrete conductors connected construction dead load diameter draft hood drain drainage ducts equipment exceed exterior walls FAN NAT FAN fastened feet Figure fireplace fixture floor flue furnace grade Ground snow load grout heaters height horizontal installed in accordance insulating concrete form insulation International Building Code joints kN/m² length less light-frame construction LINTEL listed and labeled located lumber manufacturer's installation instructions masonry material maximum metal mile per hour minimum nail NAT FAN NAT opening outlet permitted piping material pound per square pressure R-value reinforcement roof screws Seismic Design Categories sheathing slope Southern pine space square foot square inch studs thickness tion Type units valve vent connector venting system vertical wall studs wind speed Wood shingles