## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 11, Part 3American Society of Mechanical Engineers, 1992 - Arctic regions |

### From inside the book

Results 1-3 of 75

Page 92

In terms of weld metal yield strength matching , these combinations be classified

in three groups :

testing . Weld procedure tests are normally conducted on two steel coupons ...

In terms of weld metal yield strength matching , these combinations be classified

in three groups :

**Combination**B models the situation encountered in qualificationtesting . Weld procedure tests are normally conducted on two steel coupons ...

Page 244

These are first analysed separately and then

for tearing energy in each of the principal modes . are as a Calculation of fative

crack growth . To calculate fatigue crack growth , the tearing energy for each ...

These are first analysed separately and then

**combined**. The values are obtainedfor tearing energy in each of the principal modes . are as a Calculation of fative

crack growth . To calculate fatigue crack growth , the tearing energy for each ...

Page 295

solld 7 1.25 6 к 1.00 SCF 0.75 0.50 Tubular folnt detalle alpha - 1413 gamma •

14.20 lov -0.5 beta a key 2 - 30 tubular folnt FE model At deopost point 0.25 •

49 ...

solld 7 1.25 6 к 1.00 SCF 0.75 0.50 Tubular folnt detalle alpha - 1413 gamma •

14.20 lov -0.5 beta a key 2 - 30 tubular folnt FE model At deopost point 0.25 •

**Combined**equations /T=0.01 47-0.86**Combined**equations IT - 0.1 Wold anglo49 ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

ADVANCES IN STEEL AND WELDING | 65 |

Kapadia Y Adonyi J D Defilippi and W F Domis | 73 |

ThroughThickness Properties of TMCP Steels | 81 |

Copyright | |

20 other sections not shown

### Other editions - View all

### Common terms and phrases

analysis applied assessment axial base base metal bending bolt calculated carried chord combined compared complete composite compression concentration considered constant corrosion crack growth curve cycles damage defects depth determined diameter distribution edge effect elastic elements energy Engineering equations estimate experimental failure fatigue crack Figure fracture function geometry hardness heat higher hydrogen increase initial interaction International limit load material mean measured mechanical method mode observed obtained occur Offshore parameters performed pipe plastic plate predictions present pressure probability problems procedure produced properties range ratio reduced reference region Research shown shows solution specimens steel stiffness strain stress intensity factors structures subjected surface Table technique temperature tensile tension thickness thread toughness tubular joints values weld metal yield strength