Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 13, Parts 3-5American Society of Mechanical Engineers, 1994 - Arctic regions |
From inside the book
Results 1-3 of 94
Page 98
... joints . The notch effect of the weld was included in the calculations using an L / T ratio of 2 in the equations for the M1 factor . For non - nodal joints , a maximum axial stress of 0.8 σyp , as specified in [ 1 ] , was used . An ...
... joints . The notch effect of the weld was included in the calculations using an L / T ratio of 2 in the equations for the M1 factor . For non - nodal joints , a maximum axial stress of 0.8 σyp , as specified in [ 1 ] , was used . An ...
Page 109
... joints tested in air . Only the Interpolation Method was used to estimate the weldment size effect for the screened tubular joints tested in air with ẞ = t = 0.5 . The Limited Interpolation Method was not used to evaluate the weldment ...
... joints tested in air . Only the Interpolation Method was used to estimate the weldment size effect for the screened tubular joints tested in air with ẞ = t = 0.5 . The Limited Interpolation Method was not used to evaluate the weldment ...
Page 159
... joints of circular hollow sections and rectangular hollow sections 06 d0-20 Το 1 B = 1 -0.75 = 0,75 0 = 450 v = 0 3 do 2. FAILURE MODES OF HOLLOW SECTION TRUSS JOINTS The failure modes found in welded hollow section truss joints depend ...
... joints of circular hollow sections and rectangular hollow sections 06 d0-20 Το 1 B = 1 -0.75 = 0,75 0 = 450 v = 0 3 do 2. FAILURE MODES OF HOLLOW SECTION TRUSS JOINTS The failure modes found in welded hollow section truss joints depend ...
Contents
FATIGUE AND DEFORMATION | 1 |
FRACTURE ASSESSMENT AND ANALYSIS | 37 |
FATIGUE DESIGN AND DETECTION | 73 |
Copyright | |
29 other sections not shown
Other editions - View all
Common terms and phrases
analysis angle applied ASME assessment axial behaviour bending calculated cathodic protection corrosion crack growth rate crack propagation crack tip CTOD cycles deformation developed diameter displacement drillpipe dynamic elastic equation experimental factor failure fatigue crack growth fatigue strength ferrite finite element fracture mechanics fracture toughness free span geometry heat hoop stress hydrogen Ice Class increase initial installation J-Lay length limit load material maximum mbar method microstructure modulus nitrogen notch obtained offshore structures OMAE operating parameters pipe pipeline plastic Poisson's ratio predicted pressure ratio repair residual stress S-N curve scour sea ice sea water shielding gas simulated soil sour crude oil specimens steel strain rate stress intensity stress range surface Table Technology temperature tensile tubular joints values wall thickness water depth weld deposit weld metal weld toe weldment size effect wire yield strength Young's modulus