Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 13, Parts 3-5American Society of Mechanical Engineers, 1994 - Arctic regions |
From inside the book
Results 1-3 of 85
Page 184
... obtained in air ( ERFs of 0.72 and 0.99 ) ; at endurances greater than 10 cycles , there are no results in air for direct comparison , but all the data obtained in sea water ( four points ) lie above the extrapo- lated air curve giving ...
... obtained in air ( ERFs of 0.72 and 0.99 ) ; at endurances greater than 10 cycles , there are no results in air for direct comparison , but all the data obtained in sea water ( four points ) lie above the extrapo- lated air curve giving ...
Page 269
... obtained from multipass weld CGHAZ regions by taking three specimens at each level ( cup , middle and root ) are presented in Table 5. The data for the simulated microstructures are presented in Table 6. The maximum hardness values obtained ...
... obtained from multipass weld CGHAZ regions by taking three specimens at each level ( cup , middle and root ) are presented in Table 5. The data for the simulated microstructures are presented in Table 6. The maximum hardness values obtained ...
Page 299
... obtained through a combination of composition control and heat treatment . However , the microstructure of the weld ... obtained in two thicknesses : a 0.5 - inch ( 12.7 mm ) plate was obtained for the Gleeble simulation study and a 0.25 ...
... obtained through a combination of composition control and heat treatment . However , the microstructure of the weld ... obtained in two thicknesses : a 0.5 - inch ( 12.7 mm ) plate was obtained for the Gleeble simulation study and a 0.25 ...
Contents
FATIGUE AND DEFORMATION | 1 |
FRACTURE ASSESSMENT AND ANALYSIS | 37 |
FATIGUE DESIGN AND DETECTION | 73 |
Copyright | |
45 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied Arctic Engineering as-welded ASME assessment axial bending cathodic protection Charpy cold deformation corrosion crack growth rate crack propagation crack tip CTOD cycles depth diameter displacement drillpipe elastic electrode equation experimental factor failure fatigue crack growth fatigue strength ferrite finite element fracture mechanics fracture toughness geometry hoop stress hydrogen Ice Class increase load material maximum mbar Mechanics and Arctic method microstructure modulus nitrogen notch obtained Offshore Mechanics offshore structures OMAE operating oxygen parameters pipe pipeline plastic predicted pressure properties ratio region residual stress S-N curve scour sea ice sea water shear shielding gas simulated soil sour crude oil specimens strain rate stress intensity stress range stress relieved surface Table temperature tensile TMCP tubular joints values wall thickness water hammer weld deposit weld metal weld toe welded joints wire yield strength Young's modulus