Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 13, Parts 3-5American Society of Mechanical Engineers, 1994 - Arctic regions |
From inside the book
Results 1-3 of 79
Page 268
The plates were welded using Tandem SAW multipass procedure with a single bevel butt weld preparation as shown in Fig . 1. The nominal welding procedure is given in Table 3 . of 10-5 Thermal Simulation Procedure The specimens for ...
The plates were welded using Tandem SAW multipass procedure with a single bevel butt weld preparation as shown in Fig . 1. The nominal welding procedure is given in Table 3 . of 10-5 Thermal Simulation Procedure The specimens for ...
Page 9
However , high resolution inspection suggests the need for a more detailed and less conservative assessment procedure to take advantage of the improved measurement of the corrosion geometry while retaining the simplicity of the ...
However , high resolution inspection suggests the need for a more detailed and less conservative assessment procedure to take advantage of the improved measurement of the corrosion geometry while retaining the simplicity of the ...
Page 16
The same finite element model used in the Level 3 assessment ( Figure 3 ) was adopted . advantage of the more detailed knowledge of the corrosion geometry , a more accurate assessinent procedure will be desirable to assist in the ...
The same finite element model used in the Level 3 assessment ( Figure 3 ) was adopted . advantage of the more detailed knowledge of the corrosion geometry , a more accurate assessinent procedure will be desirable to assist in the ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
FATIGUE AND DEFORMATION | 1 |
Determination of Recovery Length in Spiral Strands | 9 |
FRACTURE ASSESSMENT AND ANALYSIS | 37 |
Copyright | |
36 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied assessment bending calculated compared composition considered constant corrosion crack growth CTOD curve cycles deformation dependence deposit depth determined developed distribution effect elastic electrode Engineering environment equation experimental factor failure fatigue crack Figure finite element fracture geometry given grain heat higher hydrogen increase indicate initial International joints length limit load lower material mean measured Mechanics method microstructure nitrogen notch observed obtained occur Offshore operating oxygen parameters performed phase pipe plastic plate predictions present pressure problems procedure produced propagation properties protection range ratio reduced region Research residual respectively sea water shown shows simulated specimens standard steel strain strength stress structures surface Table temperature tensile thickness toughness tubular joints values weld metal wire yield
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 13, Parts 3-5 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1994 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791812669, 9780791812662 |
| Export Citation | BiBTeX EndNote RefMan |