Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 13, Parts 3-5American Society of Mechanical Engineers, 1994 - Arctic regions |
From inside the book
Results 1-3 of 89
Page 38
This means not only that there is an optimum size of crack to produce a fracture in such a test , but also that there is ... to establish the range of toughness capable of producing a fracture for the conditions that have been applied .
This means not only that there is an optimum size of crack to produce a fracture in such a test , but also that there is ... to establish the range of toughness capable of producing a fracture for the conditions that have been applied .
Page 316
V notch impact results coefficient ) increases the energy required to produce failure . ... 5 % and controlling factor and a low rate of strain hardening may produce 10 % cold deformed Charpy - V impact specimens respectively .
V notch impact results coefficient ) increases the energy required to produce failure . ... 5 % and controlling factor and a low rate of strain hardening may produce 10 % cold deformed Charpy - V impact specimens respectively .
Page 182
In the second case , the line is fully restrained axially and thermally loaded to produce a plastic strain of ēz ... Increasing the pressure now produces an increase in hoop stress with the axial stress constrained to follow the yield ...
In the second case , the line is fully restrained axially and thermally loaded to produce a plastic strain of ēz ... Increasing the pressure now produces an increase in hoop stress with the axial stress constrained to follow the yield ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
FATIGUE AND DEFORMATION | 1 |
Determination of Recovery Length in Spiral Strands | 9 |
FRACTURE ASSESSMENT AND ANALYSIS | 37 |
Copyright | |
36 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied assessment bending calculated compared composition considered constant corrosion crack growth CTOD curve cycles deformation dependence deposit depth determined developed distribution effect elastic electrode Engineering environment equation experimental factor failure fatigue crack Figure finite element fracture geometry given grain heat higher hydrogen increase indicate initial International joints length limit load lower material mean measured Mechanics method microstructure nitrogen notch observed obtained occur Offshore operating oxygen parameters performed phase pipe plastic plate predictions present pressure problems procedure produced propagation properties protection range ratio reduced region Research residual respectively sea water shown shows simulated specimens standard steel strain strength stress structures surface Table temperature tensile thickness toughness tubular joints values weld metal wire yield
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 13, Parts 3-5 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 1994 |
| Original from | the University of Michigan |
| Digitized | 4 Dec 2007 |
| ISBN | 0791812669, 9780791812662 |
| Export Citation | BiBTeX EndNote RefMan |