Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 13, Parts 3-5American Society of Mechanical Engineers, 1994 - Arctic regions |
From inside the book
Results 1-3 of 79
Page 164
... reduction of 85 % compared with the values of uniplanar joints . If the gap between the two planes is reduced , the reduction factor can be increased up to 0.95 . This hypothesis is illustrated by Fig . 21 . 3.3 New calculation rules ...
... reduction of 85 % compared with the values of uniplanar joints . If the gap between the two planes is reduced , the reduction factor can be increased up to 0.95 . This hypothesis is illustrated by Fig . 21 . 3.3 New calculation rules ...
Page 49
... reduction for NO2 emissions is predicted to be approximately 280 tons or 3.5 percent of the base case total . 12. The benefits of reduced compression power usage in the system has been quantified in terms of reduced fuel gas use , cost ...
... reduction for NO2 emissions is predicted to be approximately 280 tons or 3.5 percent of the base case total . 12. The benefits of reduced compression power usage in the system has been quantified in terms of reduced fuel gas use , cost ...
Page 253
... reduced velocities in the range 1-3.5 . It is associated with either alternating or synimetric vortex shedding , fig . 5 ; in these conditions the response is sensitive to damping , seabed proximity , free stream turbulence and Reynold ...
... reduced velocities in the range 1-3.5 . It is associated with either alternating or synimetric vortex shedding , fig . 5 ; in these conditions the response is sensitive to damping , seabed proximity , free stream turbulence and Reynold ...
Contents
FATIGUE AND DEFORMATION | 1 |
FRACTURE ASSESSMENT AND ANALYSIS | 37 |
FATIGUE DESIGN AND DETECTION | 73 |
Copyright | |
45 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied Arctic Engineering as-welded ASME assessment axial bending cathodic protection Charpy cold deformation corrosion crack growth rate crack propagation crack tip CTOD cycles depth diameter displacement drillpipe elastic electrode equation experimental factor failure fatigue crack growth fatigue strength ferrite finite element fracture mechanics fracture toughness geometry hoop stress hydrogen Ice Class increase load material maximum mbar Mechanics and Arctic method microstructure modulus nitrogen notch obtained Offshore Mechanics offshore structures OMAE operating oxygen parameters pipe pipeline plastic predicted pressure properties ratio region residual stress S-N curve scour sea ice sea water shear shielding gas simulated soil sour crude oil specimens strain rate stress intensity stress range stress relieved surface Table temperature tensile TMCP tubular joints values wall thickness water hammer weld deposit weld metal weld toe welded joints wire yield strength Young's modulus