Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 86
Page 45
... developed and applied to fabrication of thick wall steels such as offshore structures and pressure Presented at the Seventh International Conference on Offshore Mechanics and Arctic Engineering Houston , Texas - February 7-12 , 1988 45 ...
... developed and applied to fabrication of thick wall steels such as offshore structures and pressure Presented at the Seventh International Conference on Offshore Mechanics and Arctic Engineering Houston , Texas - February 7-12 , 1988 45 ...
Page 95
... developed for Arctic offshore structures . Fundamental studies showed that the application of accelerated cooling process to extra low - carbon and niobium containing steel plates brought about high strength and excellent toughness ...
... developed for Arctic offshore structures . Fundamental studies showed that the application of accelerated cooling process to extra low - carbon and niobium containing steel plates brought about high strength and excellent toughness ...
Page 99
... developed steel plates Steel Plate Thick- Tensile Test Y S Charpy Impact Test ness ( mm ) ( MPa ) 5 ) TS ( MPa ) Loca- VE - 60 FATT tion ( J ) 50 | PA ( ° C ) YS420MPa 30 450 559 1 / 4t 274 -114 30 512 591 1 / 4t 286 -102 YS460MPa 1/4 t ...
... developed steel plates Steel Plate Thick- Tensile Test Y S Charpy Impact Test ness ( mm ) ( MPa ) 5 ) TS ( MPa ) Loca- VE - 60 FATT tion ( J ) 50 | PA ( ° C ) YS420MPa 30 450 559 1 / 4t 274 -114 30 512 591 1 / 4t 286 -102 YS460MPa 1/4 t ...
Contents
ADVANCED COMPOSITES | 1 |
PAS2tm | 9 |
OFFSHORE TECHNOLOGY GEOTECHNICAL ENGINEERING | 24 |
Copyright | |
38 other sections not shown
Other editions - View all
Common terms and phrases
abrasion addition analysis applied assessment base behaviour brittle carbon carried Charpy chemical chord compared composition concrete considered cooling critical CTOD curves cycle defect depth developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture fracture mechanics fracture toughness fusion geometry grain growth hardness heat input higher impact increase indicated initiation joint length loading lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore structures parameters performed plate position practice present pressure problem procedure production properties PWHT range reduced regions respectively sampled shown shows simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thermal thickness toughness treatment tubular joints values weld metal welded joints yield zone