Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 83
Page 147
... Joint Stiffener Position 12 . 1021 0 15 30 45 60 75 98 Angle Around The intersection From Crown Unstiffened Joint Stiftener Position Fig 4 a.Effect Of The Position Of Stiffeners On Chord SCFs For A T Joint Subject To Axial Loading ( 2 ...
... Joint Stiffener Position 12 . 1021 0 15 30 45 60 75 98 Angle Around The intersection From Crown Unstiffened Joint Stiftener Position Fig 4 a.Effect Of The Position Of Stiffeners On Chord SCFs For A T Joint Subject To Axial Loading ( 2 ...
Page 155
... joints are based on the use of an appropriate S - N diagram and Miner's law . The stress range at the hot spot point ( maximum tensile stress at the joint ) is normally obtained multiplying the nominal stress obtained from a space frame ...
... joints are based on the use of an appropriate S - N diagram and Miner's law . The stress range at the hot spot point ( maximum tensile stress at the joint ) is normally obtained multiplying the nominal stress obtained from a space frame ...
Page 159
... joint with 32 inch chord length had at the final loading stage a horizontal diameter of 18.587 inches and a vertical diameter of 13.756 inches at the central section and values of 17.873 and 13.317 inches at the end sections , deforming ...
... joint with 32 inch chord length had at the final loading stage a horizontal diameter of 18.587 inches and a vertical diameter of 13.756 inches at the central section and values of 17.873 and 13.317 inches at the end sections , deforming ...
Contents
ADVANCED COMPOSITES | 1 |
PAS2m High Performance Prepreg and Composites | 9 |
OFFSHORE TECHNOLOGY GEOTECHNICAL ENGINEERING | 24 |
Copyright | |
39 other sections not shown
Other editions - View all
Common terms and phrases
abrasion accelerated cooled analysis as-welded austenite axial boron brace brittle fracture CGHAZ Charpy Charpy-V chemical composition chord coarse grained concrete Conference on Offshore crack tip CSM CSM CTOD tests CTOD values curves defect dislocations effect electron beam welding fabrication ferrite fiber Figure finite element fracture mechanics fracture toughness fusion line grain coarsened HAZ HAZ toughness heat affected zone heat input hydrogen cracking ICCGHAZ impact increase kJ/mm layup loading low carbon martensite maximum mechanical properties Mechanics and Arctic mid-thickness niobium notch Offshore Mechanics offshore structures Oseberg parameters plastic post weld heat preheat PWHT regions residual stresses sampled solidification cracking specification specimens steel plates stiffeners strain stress concentration stress intensity factor submerged arc welding surface Table temperature tensile test results TMCP transverse tubular joints weld heat treatment weld metal weld toe weldability welded joints welding procedures weldment yield strength