Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 217
... material , use could be made of an average strain hardening index . Since the steep increase of the effec- tive strain hardening rate of the HAZ material at the onset of yielding ( up to about 1 % ) is macroscopically of secondary ...
... material , use could be made of an average strain hardening index . Since the steep increase of the effec- tive strain hardening rate of the HAZ material at the onset of yielding ( up to about 1 % ) is macroscopically of secondary ...
Page 406
... MATERIAL . The engineering mechanical properties of the plate material under static stresses are normally measured by the conventional smooth tensile test . The reported pro- perties are usually limited to the yield point ( i.e. at the ...
... MATERIAL . The engineering mechanical properties of the plate material under static stresses are normally measured by the conventional smooth tensile test . The reported pro- perties are usually limited to the yield point ( i.e. at the ...
Page 472
... material and raw material ) observed at AK 22MPa√m is shown in Fig.12 . As pH decreases , the damage of the fracture surfaces due to the corrosion is large . The unevennes- s of corrosion fatigue fracture surface becomes greater as pH ...
... material and raw material ) observed at AK 22MPa√m is shown in Fig.12 . As pH decreases , the damage of the fracture surfaces due to the corrosion is large . The unevennes- s of corrosion fatigue fracture surface becomes greater as pH ...
Contents
ADVANCED COMPOSITES | 1 |
PAS2m High Performance Prepreg and Composites | 9 |
OFFSHORE TECHNOLOGY GEOTECHNICAL ENGINEERING | 24 |
Copyright | |
39 other sections not shown
Other editions - View all
Common terms and phrases
abrasion accelerated cooled analysis as-welded austenite axial boron brace brittle fracture CGHAZ Charpy Charpy-V chemical composition chord coarse grained concrete Conference on Offshore crack tip CSM CSM CTOD tests CTOD values curves defect dislocations effect electron beam welding fabrication ferrite fiber Figure finite element fracture mechanics fracture toughness fusion line grain coarsened HAZ HAZ toughness heat affected zone heat input hydrogen cracking ICCGHAZ impact increase kJ/mm layup loading low carbon martensite maximum mechanical properties Mechanics and Arctic mid-thickness niobium notch Offshore Mechanics offshore structures Oseberg parameters plastic post weld heat preheat PWHT regions residual stresses sampled solidification cracking specification specimens steel plates stiffeners strain stress concentration stress intensity factor submerged arc welding surface Table temperature tensile test results TMCP transverse tubular joints weld heat treatment weld metal weld toe weldability welded joints welding procedures weldment yield strength