Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 78
Page 129
... measured with both reflections . = In order to derive strains from measured inter- planar spacings a reference spacing must be obtained . An average lattice parameter was computed from all the measured spacings in all three directions ...
... measured with both reflections . = In order to derive strains from measured inter- planar spacings a reference spacing must be obtained . An average lattice parameter was computed from all the measured spacings in all three directions ...
Page 130
... measured . This process , conventionally used for X - ray stress analysis where the set of ( hkl ) planes is often not aligned with the ideal texture , yields effec- tive elastic constants for translating effects in one set of grains to ...
... measured . This process , conventionally used for X - ray stress analysis where the set of ( hkl ) planes is often not aligned with the ideal texture , yields effec- tive elastic constants for translating effects in one set of grains to ...
Page 261
... measured CTOD value were the location of the fatigue crack tip relative to the fusion line and the microstructure adjacent to and slightly ahead of the crack tip . Consideration of the detailed results demonstrates the sensitivity of ...
... measured CTOD value were the location of the fatigue crack tip relative to the fusion line and the microstructure adjacent to and slightly ahead of the crack tip . Consideration of the detailed results demonstrates the sensitivity of ...
Contents
ADVANCED COMPOSITES | 1 |
PAS2tm | 9 |
OFFSHORE TECHNOLOGY GEOTECHNICAL ENGINEERING | 24 |
Copyright | |
38 other sections not shown
Other editions - View all
Common terms and phrases
abrasion addition analysis applied assessment base behaviour brittle carbon carried Charpy chemical chord compared composition concrete considered cooling critical CTOD curves cycle defect depth developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture fracture mechanics fracture toughness fusion geometry grain growth hardness heat input higher impact increase indicated initiation joint length loading lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore structures parameters performed plate position practice present pressure problem procedure production properties PWHT range reduced regions respectively sampled shown shows simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thermal thickness toughness treatment tubular joints values weld metal welded joints yield zone