Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 83
Page 289
... specimen was to simulate a small crack at a weld toe . After the pre - fatigue cracking , the specimens ( both BM and LBZ specimens ) were machined to their final shape ( B x B ) . The LBZ specimens were 35 mm and the BM specimens were ...
... specimen was to simulate a small crack at a weld toe . After the pre - fatigue cracking , the specimens ( both BM and LBZ specimens ) were machined to their final shape ( B x B ) . The LBZ specimens were 35 mm and the BM specimens were ...
Page 478
... specimens of candidate tendon alloys in sea water with and without cathodic protection and under loading conditions comparable to those expected in TLP service . EXPERIMENTAL PROCEDURE Materials and Specimens : Two types of 25.4 mm ...
... specimens of candidate tendon alloys in sea water with and without cathodic protection and under loading conditions comparable to those expected in TLP service . EXPERIMENTAL PROCEDURE Materials and Specimens : Two types of 25.4 mm ...
Page 480
... specimens failed near the fusion line on the tube side of the transverse weld . Exceptions were Specimen Y3 which broke along the weld line on the connector side and HY7 where cracks initiated on both sides of the weld . This ...
... specimens failed near the fusion line on the tube side of the transverse weld . Exceptions were Specimen Y3 which broke along the weld line on the connector side and HY7 where cracks initiated on both sides of the weld . This ...
Contents
ADVANCED COMPOSITES | 1 |
PAS2tm | 9 |
OFFSHORE TECHNOLOGY GEOTECHNICAL ENGINEERING | 24 |
Copyright | |
38 other sections not shown
Other editions - View all
Common terms and phrases
abrasion addition analysis applied assessment base behaviour brittle carbon carried Charpy chemical chord compared composition concrete considered cooling critical CTOD curves cycle defect depth developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture fracture mechanics fracture toughness fusion geometry grain growth hardness heat input higher impact increase indicated initiation joint length loading lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore structures parameters performed plate position practice present pressure problem procedure production properties PWHT range reduced regions respectively sampled shown shows simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thermal thickness toughness treatment tubular joints values weld metal welded joints yield zone