Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 7, Part 3American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 92
Page 162
... steel in this respect , 1.e. a classical normalized C - Mn steel with 0.21 % C , a modern normalized low C - Mn - Nb - Ni steel and a modern controlled rolled accelerated cooled low C - Mn - Nb - Ni - Cu steel , and a selection of the ...
... steel in this respect , 1.e. a classical normalized C - Mn steel with 0.21 % C , a modern normalized low C - Mn - Nb - Ni steel and a modern controlled rolled accelerated cooled low C - Mn - Nb - Ni - Cu steel , and a selection of the ...
Page 276
... steels . A research programme was initiated by NPD and SINTEF . Eight low carbon microalloyed steels delivered for application in offshore structures , and one St 52-3 ( 0.18 % C ) steel , were examined in the same way as described ...
... steels . A research programme was initiated by NPD and SINTEF . Eight low carbon microalloyed steels delivered for application in offshore structures , and one St 52-3 ( 0.18 % C ) steel , were examined in the same way as described ...
Page 278
... steel has a low toughness despite the low content of phosphorus . This might be due to a higher fraction of high carbon martensite observed for this steel . • CTO0.10 ° C ( a ) SAW E Steel A Steel B O Steel C O Steel D 80 Steel A . Steel B ...
... steel has a low toughness despite the low content of phosphorus . This might be due to a higher fraction of high carbon martensite observed for this steel . • CTO0.10 ° C ( a ) SAW E Steel A Steel B O Steel C O Steel D 80 Steel A . Steel B ...
Contents
ADVANCED COMPOSITES | 1 |
PAS2tm | 9 |
OFFSHORE TECHNOLOGY GEOTECHNICAL ENGINEERING | 24 |
Copyright | |
38 other sections not shown
Other editions - View all
Common terms and phrases
abrasion addition analysis applied assessment base behaviour brittle carbon carried Charpy chemical chord compared composition concrete considered cooling critical CTOD curves cycle defect depth developed direction distribution effect element energy Engineering examined fabrication factor failure fatigue crack ferrite Figure fracture fracture mechanics fracture toughness fusion geometry grain growth hardness heat input higher impact increase indicated initiation joint length loading lower material maximum measured Mechanics method microstructures normal notch observed obtained occur offshore structures parameters performed plate position practice present pressure problem procedure production properties PWHT range reduced regions respectively sampled shown shows simulated specification specimens steel steel plates stiffeners strain strength stress structures surface Table temperature tensile thermal thickness toughness treatment tubular joints values weld metal welded joints yield zone