Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 11, Part 5American Society of Mechanical Engineers, 1992 - Arctic regions |
From inside the book
Results 1-3 of 90
Page 62
... load at the stinger tip ( H ) required for pipelay , the average environmental load ( Heav ) due to wind and current , dynamic loads ( Hayn ) due to waves and wind gust , and move - up loads ( Hmove ) : H = Hpipe + Heav + Hayn + Hmove Pipe ...
... load at the stinger tip ( H ) required for pipelay , the average environmental load ( Heav ) due to wind and current , dynamic loads ( Hayn ) due to waves and wind gust , and move - up loads ( Hmove ) : H = Hpipe + Heav + Hayn + Hmove Pipe ...
Page 86
... loads ( or load effects ) multiplied by load factors that are normally greater than one , and on nominal resistances multiplied by resistance factors that are less than one . The basic requirement can be stated as : factored resistance ...
... loads ( or load effects ) multiplied by load factors that are normally greater than one , and on nominal resistances multiplied by resistance factors that are less than one . The basic requirement can be stated as : factored resistance ...
Page 244
... loads and load effects to be measured against the resistance and capacity models . Limit state functions or failure modes for the relevant load conditions and capacity models should be identified . The uncertainty analysis will then ...
... loads and load effects to be measured against the resistance and capacity models . Limit state functions or failure modes for the relevant load conditions and capacity models should be identified . The uncertainty analysis will then ...
Contents
OFFSHORE PIPELINE TECHNOLOGY | 53 |
CODESSTANDARDS AND REGULATIONS | 75 |
OFFSHORE MECHANICS AND ARCTIC ENGINEERING | 89 |
Copyright | |
22 other sections not shown
Other editions - View all
Common terms and phrases
Alberta amplitude analysis applied assessment axial bending buckling burst pressure calibrated Canadian Standards Association coefficient collapse construction corroded region corrosion corrosion pit crack criterion cylinder damper defects depth displacement distribution effect elastic Engineering environmental equation estimated evaluation failure modes failure probability fatigue damage Figure finite element flow force fractile fracture limit fracture mechanics fracture toughness frequency frost heave gas pipeline geometry hoop stress installation lift force limit state function Limit States Design load lognormal longitudinal maximum measured methods offshore pipelines OMAE operation orifice plate parameters pipe wall pipeline design pipeline spans pipeline system plastic predicted ratio reliability S-N curve safety level sample simulation SMYS soil specific standards steel stepblade strain strake stress concentration structural Submarine Pipeline Table temperature differential tensile topsoil tube bundle uncertainty usage factor variable vibration vortex shedding wall thickness weld yield strength yield stress