Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 11, Part 5American Society of Mechanical Engineers, 1992 - Arctic regions |
From inside the book
Results 1-3 of 82
Page 39
... obtained with natural gas and the dis- charge coefficients obtained from nitrogen calibrations are then used to predict the accuracy of the calculations of the natural gas critical flow function . When using the new discharge ...
... obtained with natural gas and the dis- charge coefficients obtained from nitrogen calibrations are then used to predict the accuracy of the calculations of the natural gas critical flow function . When using the new discharge ...
Page 40
... obtained from nitrogen calibration data were sys- tematically above the ISO - correlation / 1 / and approximately 0.4 % higher than the natural gas results . Van der Grinten / 2 / has also pub- lished discharge coefficients near the ...
... obtained from nitrogen calibration data were sys- tematically above the ISO - correlation / 1 / and approximately 0.4 % higher than the natural gas results . Van der Grinten / 2 / has also pub- lished discharge coefficients near the ...
Page 177
... obtained . These results are consistent with the results obtained in the initial investigation where a damping ratio of 0.4 % was obtained . For the damped section , effective damping ratios ranging from 1.8 % to 2.5 % of critical were ...
... obtained . These results are consistent with the results obtained in the initial investigation where a damping ratio of 0.4 % was obtained . For the damped section , effective damping ratios ranging from 1.8 % to 2.5 % of critical were ...
Contents
MEASUREMENT AND METERING | 1 |
OFFSHORE PIPELINE TECHNOLOGY | 53 |
CODESSTANDARDS AND REGULATIONS | 75 |
Copyright | |
12 other sections not shown
Other editions - View all
Common terms and phrases
Alberta analysis applied Arctic assessment axial bending buckling calculated calibration construction corrosion crack criteria cylinder damage defects depth developed discharge coefficient displacement distribution downstream effect Engineering environmental equation equipment estimated evaluation experimental failure probability fatigue finite element flow function fluid force fractile fracture fracture mechanics frequency frost heave function gas pipeline hoop stress installation leak detection lift force limit Limit States Design load lognormal longitudinal maximum measured Mechanics meter tube methods nozzle offshore pipelines OMAE operating orifice plate parameters pipe wall pipeline spans pipeline system Pipeline Technology ASME plastic predicted pressure ratio reliability Reynolds number S-N curve sample scour shear stress simulation soil specific standards steel strain structural Table Technology ASME 1992 temperature differential tube bundle turbulent upstream usage factor velocity profile vibration volumetric flow rate vortex shedding wall thickness weld yield strength