Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3; Volume 8, Part 3American Society of Mechanical Engineers, 1989 - Arctic regions |
From inside the book
Results 1-3 of 39
Page 70
... WELD FABRICATION Experimental investigations were conducted on submerged arc and manual metal arc welded plates . The base metals used were a modified T StE 355 for the submerged arc welds and a StE 355 corresponding to BS 4360 Grade 50 ...
... WELD FABRICATION Experimental investigations were conducted on submerged arc and manual metal arc welded plates . The base metals used were a modified T StE 355 for the submerged arc welds and a StE 355 corresponding to BS 4360 Grade 50 ...
Page 312
... submerged arc welds at a heat input of 3.5KJ / mm for the fill and cap regions of the weld . A straight edged single bevel weld preparation was used . The welding consumables chosen for this programme were OE - SD3 1Ni Mo wire with ...
... submerged arc welds at a heat input of 3.5KJ / mm for the fill and cap regions of the weld . A straight edged single bevel weld preparation was used . The welding consumables chosen for this programme were OE - SD3 1Ni Mo wire with ...
Page 313
... submerged arc welding consumables with and without powder additions satisfy the strength and toughness requirements in both the as welded and PWHT conditions . of this This paper has described the development submerged arc welding ...
... submerged arc welding consumables with and without powder additions satisfy the strength and toughness requirements in both the as welded and PWHT conditions . of this This paper has described the development submerged arc welding ...
Contents
OFFSHORE MECHANICS | 1 |
MATERIALS TECHNOLOGY | 9 |
The Plate Thickness Effect in Fatigue Predictions and Results A Review of Norwegian Work | 21 |
Copyright | |
50 other sections not shown
Other editions - View all
Common terms and phrases
alloy aluminum analysis applied Arctic Engineering ASTM austenite axial base metal behaviour bending brace calculated cathodic protection Charpy chord Conference on Offshore corrosion fatigue crack depth crack growth rate crack initiation crack propagation crevice corrosion CTOD da/dN defects developed energy environment equation experimental fabrication fatigue crack growth fatigue strength fatigue test ferrite Figure fillet welds finite element fracture mechanics fracture toughness geometry grade heat input heat treatment HSLA steels increase influence kJ/cm load material mechanical properties Mechanics and Arctic method microstructure notch obtained Offshore Mechanics offshore structures parameters pipe pitting plate thickness predicted procedure PWHT ratio reduced S-N curves seawater Shoralsim shown in Fig solution specimens Steel in Marine strain stress concentration stress intensity factor stress range submerged arc welding surface crack T-joints Table temperature tensile thickness effect tubular joints values weld metal weld profile weld toe weldability welded joints yield strength