## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 10, Part 5American Society of Mechanical Engineers, 1991 - Arctic regions |

### From inside the book

Results 1-3 of 43

Page 14

Other

semi - circular cylinder radius ) , La = 50 , x , = 30 , At = 0 . 15 . For the wave

height H = 0 . 3 , two different wave length cases are considered . For 1 = 7 , we

have ...

Other

**parameters**are kept the same for different wavelengths , i . e . , a = 0 . 5 (semi - circular cylinder radius ) , La = 50 , x , = 30 , At = 0 . 15 . For the wave

height H = 0 . 3 , two different wave length cases are considered . For 1 = 7 , we

have ...

Page 21

NONLINEAR CORRECTION The bending deflections and the

split into a linear and a nonlinear part : total = linear + nonlinear un ( s , t ) = uon (

s , t ) + uin ( s , t ) = dyn . bending deflection ( N ) Ub ( s , t ) = uob ( s , t ) + 213 ( s ,

t ) ...

NONLINEAR CORRECTION The bending deflections and the

**parameters**aresplit into a linear and a nonlinear part : total = linear + nonlinear un ( s , t ) = uon (

s , t ) + uin ( s , t ) = dyn . bending deflection ( N ) Ub ( s , t ) = uob ( s , t ) + 213 ( s ,

t ) ...

Page 107

The

accumulation law . A lognormal ... Fatigue damage is estimated above on the

basis of PIPE calculations where the governing

deterministically .

The

**parameter**A has been used to represent the uncertainty in the damageaccumulation law . A lognormal ... Fatigue damage is estimated above on the

basis of PIPE calculations where the governing

**parameters**are treateddeterministically .

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

Design of the Troll Multiphase Transport System | 1 |

Propagation and Diffraction of Cnoidal Waves | 9 |

Dynamic Stresses and Motions of Offshore Pipelines During Laying | 17 |

Copyright | |

25 other sections not shown

### Other editions - View all

### Common terms and phrases

analysis applied axial base bending boundary calculated carbon cause coating combined composition considered cooling corrosion crack curve cycle damage defects depth determined developed dew point diameter direction distribution dynamic effect element equation equipment experiments factor failure fatigue field Figure flaws flow force fracture frequency function girth welds given grade hardness heat higher increase installation internal length limit load lower material maximum measured mechanical method monitor obtained offshore operation parameters pass pipe pipeline plate point temperature position possible predicted present pressure problem procedure production propagation properties range reduced relative Research shown shows simulation span specified Specimen steel strength stress surface Table Technology temperature tensile tension toughness tube wall thickness wave weld metal welded joint yield